Zanussi ZDT26022FA User Manual

Problem and alarm code Possible cause and solutionThe program does not start. • Make sure that the appliance door is closed.• If the delay start is set, cancel the setting or wait for the end ofthe countdown.• The appliance has started the procedure to recharge the resininside the water softener. The duration of the procedure is ap-proximately 5 minutes.The appliance does not fill withwater.The display shows or.• Make sure that the water tap is open.• Make sure that the pressure of the water supply is not too low.For this information, contact your local water authority.• Make sure that the water tap is not clogged.• Make sure that the filter in the inlet hose is not clogged.• Make sure that the inlet hose has no kinks or bends.The appliance does not drainthe water.The display shows .• Make sure that the sink spigot is not clogged.• Make sure that the filter in the outlet hose is not clogged.• Make sure that the interior filter system is not clogged.• Make sure that the drain hose has no kinks or bends.The anti-flood device is on.The display shows .• Close the water tap and contact an Authorised Service Centre.The appliance stops and startsmore times during operation.• It is normal. It provides optimal cleaning results and energy sav-ings.The program lasts too long. • Select the TimeManager option to shorten the program time.• If the delayed start option is set, cancel the delay setting or waitfor the end of the countdown.The remaining time in the dis-play increases and skips nearlyto the end of program time.• This is not a defect. The appliance is working correctly.Small leak from the appliancedoor.• The appliance is not levelled. Loosen or tighten the adjustablefeet (if applicable).• The appliance door is not centred on the tub. Adjust the rearfoot (if applicable).The appliance door is difficultto close.• The appliance is not levelled. Loosen or tighten the adjustablefeet (if applicable).• Parts of the tableware are protruding from the baskets.Rattling/knocking sounds frominside the appliance.• The tableware is not properly arranged in the baskets. Refer tobasket loading leaflet.• Make sure that the spray arms can rotate freely.The appliance trips the circuit-beaker.• The amperage is insufficient to supply simultaneously all the ap-pliances in use. Check the socket amperage and the capacityof the meter or turn off one of the appliances in use.• Internal electrical fault of the appliance. Contact an AuthorisedService Centre.31