Zanussi ZDT311 User Manual

Also see for ZDT311: User manual User manual

Zanussi ZDT311 User Manual Manual pdf 23 page image

1 2Set switch to position 1 or2.Electronic adjustmentThe water softener is set at the factory at level 5.1. Switch on the appliance.2. Make sure that the appliance is in setting mode.3. Press and hold function buttons B and C until theindicator lights for function buttons A, B and C startto flash.4. Release function buttons B and C.5. Press function button A.– The indicator light for function button A continuesto flash.– The indicator lights for function buttons B and Cgo off.– The end indicator light starts to flash.– You can hear an audible signal.The setting function of the water softener is activated.The end indicator light flashes and an audible signaloperates to show the level of the water softener. Thepause is approximately 3 seconds.Example: 5 flashes / 5 intermittent audible signals -pause - 5 flashes / 5 intermittent audible signals -pause - etc... = level 56. Press the function button A one time to increase thewater softener level by one step.7. Press the on/off button to save the operation.Use of dishwasher saltCaution! Only use dishwashers salt. Types of saltthat are not applicable for dishwashers causedamage to the water softener.1 23Fill the salt container with1 litre of water (only thefirst operation).45 6It is normal that water overflows from the salt con-tainer when you fill it with salt.Make sure that there is no grain of salt outer of thesalt compartment. Salt which stays on the tank fora while drills the tank. It is recommended to start a wash-ing programme immediately after you fill the salt con-tainer. This prevents of corrosion because of spilled salt.When you set electronically the water softener to level 1,the salt indicator light does not stay on.23