Zanussi ZFC31401WA User Manual

Also see for ZFC31401WA: User manual User manual

Contents

• Make sure that the mains plug is accessibleafter the installation of the appliance.Service• Any electrical work required to do the servic-ing of the appliance should be carried out bya qualified electrician or competent person.• This product must be serviced by an author-ized Service Centre, and only genuine spareparts must be used.Environment ProtectionThis appliance does not contain gasseswhich could damage the ozone layer, in ei-ther its refrigerant circuit or insulation materials.The appliance shall not be discarded togetherwith the urban refuse and rubbish. The insula-tion foam contains flammable gases: the appli-ance shall be disposed according to the appli-cable regulations to obtain from your local au-thorities. Avoid damaging the cooling unit, espe-cially at the rear near the heat exchanger. Thematerials used on this appliance marked by thesymbol are recyclable.OperationSwitching onInsert the plug into the wall socket.Turn the Temperature Regulator to the Full Loa-ded position and let the appliance run for 24hours to allow the correct temperature to bereached before placing food inside.Adjust the Temperature Regulator according tothe quantity of the stored foods.BCAA Temperature RegulatorB Half Loaded positionC Full Loaded positionSwitching offTo turn off the appliance, turn the TemperatureRegulator to the “OFF” position.Temperature regulationThe temperature within the appliance is control-led by the Temperature Regulator situated onthe control panel.To operate the appliance, proceed as follows:• turn the Temperature Regulator toward lowersettings to obtain the minimum coldness.• turn the Temperature Regulator toward highersettings to obtain the maximum coldness.In case of freezing less food volumes, theHalf Loaded setting is the most suitable.In case of freezing much food volumes, the FullLoaded setting is the most suitable.Control panel21 31 Temperature regulator2 Pilot light3 High temperature alarm lightHigh temperature alarmAn increase in the temperature in the freezer (forexample due to an power failure) is indicated byswitching on of the Alarm lightDuring the alarm phase, don't place food insidethe freezer.When normal conditions are restored the Alarmlight will switch off automatically.14 www.zanussi.comwww.preciz.hu