Zanussi ZFC31401WA User Manual

Also see for ZFC31401WA: User manual User manual

Contents

• Do not use mechanical devices or other means to acceleratethe defrosting process, other than those recommended by themanufacturer.• Do not damage the refrigerant circuit.• Do not use electrical appliances inside the food storagecompartments of the appliance, unless they are of the typerecommended by the manufacturer.• Do not use water spray and steam to clean the appliance.• Clean the appliance with a moist soft cloth. Only use neutraldetergents. Do not use abrasive products, abrasive cleaningpads, solvents or metal objects.• Do not store explosive substances such as aerosol cans with aflammable propellant in this appliance.• If the supply cord is damaged, it must be replaced by themanufacturer, its service agent or similarly qualified persons inorder to avoid a hazard.Safety instructionsInstallationWARNING!Only a qualified person must installthis appliance.• Remove all the packaging.• Do not install or use a damaged appliance.• Obey the installation instruction suppliedwith the appliance.• Always be careful when you move theappliance because it is heavy. Always wearsafety gloves.• Make sure the air can circulate around theappliance.• Wait at least 4 hours before connecting theappliance to the power supply. This is toallow the oil to flow back in the compressor.• Do not install the appliance close toradiators or cookers, oven or hobs.• The rear of the appliance must stand againstthe wall.• Do not install the appliance where there isdirect sunlight.• Do not install this appliance in areas that aretoo humid or too colds, such as theconstruction appendices, garages or winecellars.• When you move the appliance, lift it by thefront edge to avoid scratching the floor.Electrical connectionWARNING!Risk of fire and electrical shock.• The appliance must be earthed.• All electrical connections should be made bya qualified electrician.• Make sure that the electrical information onthe rating plate agrees with the powersupply. If not, contact an electrician.• Always use a correctly installed shockproofsocket.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage to theelectrical components (e.g. mains plug,mains cable, compressor). Contact theService or an electrician to change theelectrical components.• The mains cable must stay below the level ofthe mains plug.• Connect the mains plug to the mains socketonly at the end of the installation. Make surethat there is access to the mains plug afterthe installation.www.zanussi.com 15