Zanussi ZFC639WAP User Manual

Also see for ZFC639WAP: User manual

Problem Possible cause SolutionThere is too much frost and ice. Products are not wrapped properly. Wrap the products better.The lid is not shut properly or do notclose tightly.Check if the lid closes well and the gas-kets are undamaged and clean.The temperature is not set correctly. Set a warmer temperature.The water drainage plug is not cor-rectly positioned.Position the water drainage plug in thecorrect way.The lid doesn't close completely. There is excessive frost. Eliminate excess frost.The lid gaskets are dirty or sticky. Clean the lid gaskets.Food packages are blocking the lid. Arrange the packages in the right way,see the sticker in the appliance.The lid is difficult to open. The lid gaskets are dirty or sticky. Clean the lid gaskets.The valve is blocked. Check the valve.The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".It is too warm in the freezer. The temperature is not set correctly. Set a lower temperature.The lid does not close tightly or it isnot shut properly.Check if the lid closes well and the gas-ket is undamaged and clean.Before freezing the appliance was notprecooled sufficiently.Pre-cool the appliance for enough time.Large quantities of food to be frozenwere put in at the same time.Wait some hours and then check thetemperature again. Next time insertsmaller quantities of food to be frozen atany one time.Food placed in the appliance was toowarm.Allow food to cool to room temperaturebefore storing.Products to be frozen are placed tooclosely to each other.Place the products in a way so that coldair could circulate among them.The lid has been opened often. Try to not open the lid often.The lid has been opened for a longtime.Do not leave the lid open longer thannecessary.It is too cold inside the freezer. The temperature is not set correctly. Set a warmer temperature.The appliance does not work atall. Neither cooling nor lightingworks.Plug is not connected to the mainssocket properly.Connect the mains plug properly.Power does not reach the appliance. Try connecting another electrical deviceto the power outlet.The appliance is not switched on. Switch on the appliance.17