11F O2564 FO 20443Dimensions are given in mm.Building InBuilding over a cupboard ordrawerIf the hob is to be installed above a cupboard or drawer itwill be necessary to fit a heat resistant board below thebase of the hob on the underside of the work surface.It is also recommended to carry out the electricalconnection to the hob as shown in diagrams 1 and 2.Building over a kitchen unit withdoorProper arrangements must be taken in designing thefurniture unit, in order to avoid any contact with the bottomof the hob which can be heated when it is operated. Therecommended solution is shown in diagram 3.The panel fitted under the hob ("a") should be easilyremovable to allow easy access if technical assistanceis needed. The space behind the kitchen unit ("b") canbe used for connections.1FO 25632)Fitting the Hob into the worktopCarry out the building in of the hob as follows:• put the seals supplied with the hob, on theedges of the cut out: place them at 8 mmfrom the front and rear edges of the cutout and at 50 mm from the side edges,as shown in the diagram, taking care thatthe seals meet without overlapping;• place the hob in the cut out, taking care that itis centred;• fix the hob with the relevant fixing clamps andscrews, as shown in the diagram. When thescrews have been tightened, the excess sealcan be removed.The edge of the hob forms a double seal which preventsthe ingress of liquids.