Zanussi ZGG 646 Operating Instructions Manual

Also see for ZGG 643: Instruction booklet

Contents

15Connection using flexible non metal pipesWhen the connection can be easily inspected in its full extent, there is the chance to use a flexible pipeaccording to the rules in force. The flexible pipe must be tightly fixed using clamps according to the rulesin force.Always insert the gasket «B». Then proceed with the gas connection. The flexible pipe should bemade ready for use in such a way that:- nowhere it can reach overtemperature, other than room temperature, higher than 30°C; if theflexible pipe, to reach the cock, must run behind the range, it must be installed as shown in Fig. 3;- it is no longer than 1500 mm;- it shows no throttles;- it is not subject to traction or torsion;- it doesn't get in touch with cutting edges or corners;-it can be easily inspected in order to check its condition.The control of preservation of the flexible pipe consistsin checking that:- it doesn't show cracks, cuts, marks of burnings bothon the end parts and on its full extent;- the material is not hardened, but shows its normalelasticity;- the fastening clamps are not rusted;- expiry term is not due.If one or more abnormalities are seen, do not repair thepipe, but replace it.It is important to install the elbow correctly, with theshoulder on the end of the thread, fitted to the hobconnecting pipe.Failure to ensure the correct assembly will causeleakage of gas.IMPORTANTOnce installation is complete, check the perfectsealof every pipe fitting, using a soapy solution, nevera flame.Natural gasFig. 3A) Ramp with ending nutB) SealC) Adjustable connection