Zanussi ZGG 646 Operating Instructions Manual

Also see for ZGG 643: Instruction booklet

Contents

7Hob BurnersTo light a burner:z turn the relevant knob anticlockwise tomaximum position and push down the knob toignite.z After lighting the flame, keep the knob pusheddown for about 5 seconds. This will allow the"thermocouple" (Fig. 2 - lett. D) to be heatedand the safety device to be switched off,otherwise the gas supply would be interrupted.Then, check the flame is regular and adjust itas required.If you cannot light the flame even after severalattempts, check the "cap" (Fig. 1 - lett. A) and“crown” (Fig. 1 - lett. B) are in the correct position.To put the flame out, turn the knob to the symbol.In the absence of electricity, ignition canoccur without the electrical device; in this case approach the burner with aflame, push the relevant knob down and turn it anti-clockwise until it reachesthe"maximum" position.When switching on the mains, after installation or a power cut, it is quite normalfor the spark generator to be activated automatically.Operation)))))Fig. 1A - Burner capB - Burner crownC - Ignition electrodeD - ThermocoupleINSTALLATIONAny gas installation must be carried out by qualified personnel, and inaccordance with existing rules and regulations.The relevant instructions are to be found in the second section of this manual.Please, ensure that, once the hob is installed, it is easily accessible for theengineer in the event of a breakdown.The manufacturer will not accept liability, should the above instructions or anyof the other safety instructions incorporated in this book be ignored.WHEN THE HOB IS FIRST INSTALLEDOnce the hob has been installed, it is important to remove any protective materials,which were put on in the factory.