Zanussi ZGG65414 User Manual

Also see for ZGG65414: User manual User manual User manual

Contents

edges of the hob is 400 mm. If it is fitted below400 mm a space of 50 mm must be allowedfrom the edges of the hob.For appliances installed in the Republic of Ire-land please refer to NSAI- Domestic Gas In-stallation I.S 813 Current Edition Section 7-Permitted Locations of Appliance.Gas ConnectionWarning! Any gas installation must becarried out by a GAS SAFE REGISTERinstaller.Make sure that, once the hob is installed, it iseasily accessible for the engineer in the eventof a breakdown.The manufacturer will not accept liability,should the above instructions or any of the oth-er safety instructions incorporated in this in-struction booklet be ignored.On the end of the shaft, which includes the G1/2" threaded elbow, adjustment is fixed so thatthe washer is fitted between the componentsas shown in the diagram. Screw the parts to-gether without using excessive force.1231 End of shaft with nut2 Washer3 ElbowConnection to the gas supply should be witheither rigid or semi-rigid pipe, i.e. steel or cop-per.The connection should be suitable for connect-ing to R 1/2 (1/2 BSP male thread).When the final connection has been made, it isessential that a thorough leak test is carried outon the hob and installation.Make sure that the main connection pipe doesnot exert any strain on the hob.If you use flexible metal pipes make sure thatthey agree to ISO 10380 and ISO 10807standards. Be careful they do not come intouch with mobile parts or they are notsqueezed. Also be careful when the hob is puttogether with an oven.Important! It is important to install the elbowcorrectly, with the shoulder on the end of thethread, fitted to the hob connecting pipe.Important! Failure to ensure the correctassembly will cause leakage of gas.Important! Make sure that the gas supplypressure of the appliance obeys therecommended values.Rigid connection:Carry out connection by using metal rigid pipes(copper with mechanical end).Injectors replacement1. Remove the pan supports.2. Remove the caps and crowns of the burn-er.3. With a socket spanner 7 remove the injec-tors and replace them with the ones whichare necessary for the type of gas you use(see table in "Technical Data" chapter).4. Assemble the parts, follow the same pro-cedure backwards.5. Replace the rating plate (it is near the gassupply pipe) with the one for the new typeof gas supply. You can find this plate in thepackage supplied with the appliance.If the supply gas pressure is changeable or dif-ferent from the necessary pressure, you must fitan applicable pressure adjuster on the gas sup-ply pipe.Adjustment of minimum levelTo adjust the minimum level of the burners:1. Light the burner.2. Turn the knob on the minimum position.3. Remove the knob.5www.zanussi.com