Zanussi ZKF 641 X Installation And Operating Instructions Manual

Contents

Zanussi ZKF 641 X Installation And Operating Instructions Manual Manual pdf 15 page image

15Installation Instructions1 Important! The new appliance may only be in-stalled and connected by qualified person-nel.Please observe this instruction, otherwise thewarranty will not cover any damage that mayoccur.Technical DataAppliance dimensionsWorktop cut-out dimensionsCooking ringsRegulations, Standards,DirectivesThis appliance meets the following standards:• EN 60 335-1 and EN 60 335-2-6relating to the safety of electrical appliances forhousehold use and similar purposes and• EN 60350, or DIN 44546 / 44547 / 44548relating to the operating features of electric coo-kers, hobs, ovens, and grills for household use.• EN 55014-2• EN 55014• EN 61000-3-2• EN 61000-3-3• relating to basic requirements for electro-magneticcompatibility protection (EMC).5 This appliance complies with the following EUDirectives:• 73/23/EWG dated 19.02.1973 (Low Voltage Direc-tive)• 89/336/EWG dated 03.05.1989 (EMC Directive in-cluding Amending Directive 92/31/EWG).1 Safety Instructions forthe Installer• A device must be provided in the electrical installa-tion which allows the appliance to be disconnectedfrom the mains at all poles with a contact openingwidth of at least 3 mm.Suitable isolation devices include line protectingcut-outs, fuses (screw type fuses are to be re-moved from the holder), earth leakage trips andcontactors.• In respect of fire protection, this appliance corre-sponds to EN 60 335-2-6. This type of appliancemay be installed with a high cupboard or wall onone side.• Drawers may not be fitted underneath the hob.• The installation must guarantee shock protection.• The kitchen unit in which the appliance is fittedmust satisfy the stability requirements ofDIN 68930.• For protection against moisture, all cut surfacesare to be sealed with a suitable sealant.• On tiled work surfaces, the joints in the area wherethe hob sits must be completely filled with grout.• Ensure that the seal is correctly seated against thework surface without any gaps. Additional siliconsealant must not be applied; this would make re-moval more difficult when servicing.• The hob must be pressed out from below when re-moved.For Australia:• CAUTION: The surface temperature exceeds 95°C.To avoid a hazard, underbench access must be re-stricted.• The cable used to connect the appliance to themains electricity supply must have a minimumtemperature rating of V90HT for the complete dis-tance of cable run under the hob.Width 572 mmDepth 502 mmHeight 47 mmWidth 560 mmDepth 490 mmCorner radius R5Position Diameter PowerFront left 180mm 1700WRear left 180mm 1700WRear right 145mm 1200WFront right 145mm 1200WConnection voltage 230 V ~ 50HzMaximum connected load power 5,8kW