Zanussi ZUT 133W6 Instruction Book

Also see for ZUT 133W6: Instruction book

Contents

16Refit the upper hinge pin into the opposite location.Fit the door in place on the hinge pin.Slot the hinge pin into the hole in the hinge plateand relocate the hinge assembly to the oppositelocation and refit using the retaining screws.Refit the bottom hinge plate assembly on theopposite side, taking care that the edge of the dooris parallel with the side of the cabinet.To reverse the handle proceed as follows:Remove screw covers (if fitted) and handle retainingscrews. Remove blanking plugs on the oppositeside using a punch.Relocate the handle to the opposite side and refitretaining screws (covers if fitted), and push theplastic plugs supplied with the instruction book intothe holes where the handle was previously fitted.Electrical ConnectionElectrical ConnectionAny electrical work required to install thisappliance should be carried out by aqualified electrician or competent person.This appliance must be earthed.The manufacturer declines any liability shouldthese safety measures not be observed.Electrical RequirementsBefore switching on, make sure the electricity supplyvoltage is the same as that indicated on the appliancerating plate.The appliance is supplied with a 13 amp plug fitted. Inthe event of having to change the fuse in the plugsupplied, a 13 amp ASTA approved (BS 1362) fusemust be used. Should the plug need to be replaced