17Installation Instructions1 Safety instructionsWarning! This must be read!The laws, ordinances, directives and standards in force in the country of useare to be followed (safety regulations, proper recycling in accordance withthe regulations, etc.)Installation may only be carried out by a qualified electrician.The minimum distances to other appliances and units are to be observed.Anti-shock protection must be provided by the installation, for exampledrawers may only be installed with a protective floor directly underneath theappliance.The cut surfaces of the worktop are to be protected against moisture usinga suitable sealant.The sealant seals the appliance to the work top with no gap.The sealant seals the appliance to the work top with no gap.Do not use silicon sealant between the appliance and the work top.Avoid installing the appliance next to doors and under windows. Otherwisehot cookware may be knocked off the rings when doors and windows areopened.z Risk of injury from electrical current.• The electrical mains terminal is live.• Make electrical mains terminal free of voltage.• Follow connection schematic.• Observe electrical safety rules.• Ensure anti-shock protection by installing correctly.• The appliance must be connected to the electrical supply by a qualifiedelectrician.z Risk of injury from electrical current.• Loose and inappropriate plug and socket connections can make the ter-minal overheat.• Have the clamping connections correctly installed by a qualified electri-cian.• Use strain relief clamp on cable.• In the event of single-phase or two-phase connection, the appropriatemains cable of type H05BB-F Tmax 90°C (or higher) must be used.• If this appliance’s mains cable is damaged, it must be replaced by a spe-cial cable (type H05BB-F Tmax 90°C; or higher). Please contact your localService Force Center for further advice.