Zenith H19F34DT Installation And Operating Manual, Warranty

P A G E 1 6 206-3599-OFine-tuning the guest’s channel selection listChannel Add/Delete/BlankPress the MENU key on an Installer’s remote so the SETUP MENUappears.Press SELECT repeatedly to go to the Add/Del/Blnk option.Using either the NUMBER keypad and ENTER or the ChannelUp/Down arrows on the remote, select a channel. (If adding adeleted channel, you will need to use the number keypad andENTER.)Using the Right/Left ADJ arrows, pick whether that channel isAdded, Deleted, or Blank.To continue, select another channel and repeat from Step 3.When you are finished, press ENTER to remove menu.Adding Aux, VCR 3, or VCR 4 to the ChannelPreview ListGo to the Setup menu, select the Add/Del/Blnk option. UseChannel Up/Down to select the option and choose Added.Note: If the option was turned off in the Service menu, you willhave to reinstate it before it can appear as an option in theChannel Preview list.Note: You can Add, Delete, or Blank: VCR 3, VCR 4, and Aux.Caution: If you delete CH3, VCR3 is deleted also, if you deleteCH4 VCR4 is deleted also, and vice versa.12345TIMERCH PREVIEWENTER1 2 34 5 67 8 90POWERFLSHBKMUTEVOLUMECHANNELTV/FMCCMENU ALARMADJ ADJSELECT2CH 44 ADDEDAUTO PROGRAMADD/DEL/BLNKCH. LABELSCLOCK SETTIMERCAPTIONSLANGUAGESETUP MENUMini glossaryADD Adds new channels to the list that the guest can scroll through when using the remote.DELETE Removes channels for one reason or another from the list that the guest can scroll through.BLANK Removes the video signal from a channel so the guest will only receive the audio signal.43/51If you delete a channel, it isn’t gone for good. Just select itusing the NUMBER keypad on the remote, or add it later.33