Zenith H19F34DT Installation And Operating Manual, Warranty

P A G E 3 9206-3490-OClone Selection Menu ChoicesOperation NotesDisconnect the Clone from the TV when you are finished; auto-matically switching it off. The real-time clock continues to runwhen the main circuits are switched off.Reset Clone After Static ShockAfter replacing exhausted batteries, or if the programmerbehaves strangely after a static shock, use a paper clip or similarinstrument inserted through the small hole marked ”RESET” toactivate the internal reset switch and restore normal operation.After a reset, check the real-time clock setting. It may be neces-sary to reset the Clone Programmer clock from a TV containingthe correct time.The LT2000 programmer is designed to be used with TVs contain-ing the 221-01006 and later processors. Usage with earlier TVsets may give unpredictable results. The specific microprocessorused in any TV set can be determined by activating the InstallerMenu. The microprocessor part number appears at the top of thescreen when the Installer Menu is activated. Processors beforethe 221-01006-04 have a limited screen display capability. Theycannot display entire screens as shown in the quick setupinstructions accompanying the LT2000 clone programmer. Use theprinted menu illustrations on the quick setup sheet supplied withthe Clone as an aid to making your programming choices.(Although the menus are not all displayed, the clone functionsall operate normally.)When cloning operations are complete, just unplug the LT2000 from the TV.If the TV does not display a picture (blank screen) after a few seconds, just change channels.TroubleshootingProblem Possible Cause(s) Possible Solution(s)Clone ProgrammerLED does not blink. • M.P.I. cord not connected. -Connect M.P.I. cord.• TV not turned on. -TV must be on for clone to work.• Weak batteries. -Install 4 fresh AA high-quality alkaline batteries.Clone menu hard • Weak signal. -Connect TV to a reliable signal source.to read.No time set. • No time on master TV. -Set time on master TV, copy time to Clone Programmer.Menu items 7-8 not • Not necessary. -Channel Labels already cloned; if they were on master TV.on clone selection menu.Master and Other TVsCloning did not work. • Procedure interrupted. -Wait until procedure complete message is displayed.• Different TV models. -Cloning is only possible with identical model TVs.Clone time disappeared. • Batteries were removed. -Batteries must remain installed to retain time settings.Channel Labels not • Saved to other memory. -Must save channel labels to same memory bank aspresent on cloned TV. master TV setup.New Setup not present. • TV not reset. -Disconnect newly cloned TV from power for 5 seconds.