Zenith P50W38 Installation And Operating Manual

Also see for P50W38: Installation and operating guide Installation and operating guide Service manual

30 Plasma Display PanelExternal Control Device Setup27. ISM Method (Command2:p)G To avoid having a fixed image remain on screen.TransmissionData 0: Normal1: White wash2: Orbiter3: Inversion[j][p][ ][Set ID][ ][Data][Cr]Acknowledgement[p][ ][Set ID][ ][OK][Data][x]28. Low Power (Command2:q)G To control the low power function on/off.TransmissionData 0: Low power off1: Low power on[j][q][ ][Set ID][ ][Data][Cr]Acknowledgement[q][ ][Set ID][ ][OK][Data][x]29. Orbiter Time Setting (Command2:r)G To adjust orbiter operation time term.TransmissionData Min: 1 ~ Max: FE[j][r][ ][Set ID][ ][Data][Cr]Acknowledgement[r][ ][Set ID][ ][OK][Data][x]30. Orbiter Pixel Setting (Command2:s)G To adjust pixel number in orbiter function.TransmissionData Min: 0 ~ Max: 9[j][s][ ][Set ID][ ][Data][Cr]Acknowledgement[s][ ][Set ID][ ][OK][Data][x]32. Auto Configure (Command2:u)G To adjust picture position and minimize image shakingautomatically. Auto Configure only works in RGB-PCmode.TransmissionData 1: To set[j][u][ ][Set ID][ ][Data][Cr]Acknowledgement[u][ ][Set ID][ ][OK][Data][x]31. Picture Size Setting for Twin Picture mode(Command2:t)G To adjust main picture size in twin picture mode.TransmissionData Min: 0 ~ Max: 64• Refer to ‘Real data mapping1’. See page 27.[j][t][ ][Set ID][ ][Data][Cr]Acknowledgement[t][ ][Set ID][ ][OK][Data][x]25. PIP Input Select (Command2:y)G To select input source for sub picture in PIP mode.TransmissionData 0: RGB 1: Component2: Video 3: S-video 4: DVI[k][y][ ][Set ID][ ][Data][Cr]Acknowledgement[y][ ][Set ID][ ][OK][Data][x]26. Abnormal State (Command2:z)G To recognize an abnormal state.TransmissionData 0: Normal (Power on and signal exist)1: No signal (Power on)2: Turn the monitor off by remote control3: Turn the monitor off by sleep time function4: Turn the monitor off by RS-232C function5: 5V down6: AC down7: Turn the monitor off by Fan Alarm function8: Turn the monitor off by off time function9: Turn the monitor off by auto off functiona: Turn the monitor off by AV board detect[k][z][ ][Set ID][ ][FF][Cr]Acknowledgement[z][ ][Set ID][ ][OK][Data][x]Data FF:Read