Zenith SM2771S Operating Manual & Warranty

Also see for SM2738RK: Operating guide & warranty

Zenith SM2771S Operating Manual & Warranty Manual pdf 18 page image

REMOTE CONTROL MODEL MBR3420/MBR3430PROGRAMMING BRAND CODESBefore using your new rcmotc control, it must bc programmedto recognize the brands of equipment it will be used tooperate. If you are using a Zenith TV, Zenith VHS VCR or aZenith cable-TV decoder, it has already been programmed foryOU.Find the code that corresponds to each brand and type ofequipment you are going to operate. Refer to Tables 1, 2and 3.For example, if you were programming the remote for usewith a Zenith TV, you would look up "Zenith" in "Table1.", and find code "101."Write the brand codes for your equipment on the followinglines.TV CODE:CABLE CODE:1. Press MODE rcpeatedly to select the desired TV,VCR or CABLE operating mode for the remote.2. Press LEARN for about 5 seconds until the MODEindicator lights for the selected TV, VCR orCABLE mode of operation.3. Enter the proper brand code number for the equip-ment to be controlled.4. Press LEARN. All three mode indicators shouldlight briefly, then turn off to indicate the brand codehas been programmed.5. If all three mode indicators fail to light briefly, anerror has occurred. Repeat steps 1-4 to try again.6. Repeat steps 1-4 to program the remote for theother equipment you are using.NOTE: CABLE mode can be programmed to operate asecond TV or second VCR, if desired.When batteries are removed: It will be necessary torcprogram the proper VCR and cable-TV decoder codes.VCRCODE:Operating ModeIndicatorsNumbered ButtonsUsed to enter code numberfor desired brand nameLEARN ButtonSELECT QUIT®®®®®®®®®PIP FREEZE_ C_SWAP TIMERC223 C5E3 C3DRECORD STOP PAUSE(SE) CED C_3REW PLAY F FWDkMBR3430 is ShownOperating MODE Button.'743-o 4 -- 6