Zenith SM2784BT Operating Manual & Warranty

Zenith SM2784BT Operating Manual & Warranty Manual pdf 11 page image

THE FIRST TIME YOU OPERATE YOUR TVSTEP 1. CONNECT THE POWERA. Plug your TV into an unswitched AC power source.B. Turn the TV ON by pressing OFF-ON.NIDo not plug TV into switched outleton cable-TV decoder or VCRSTEP 2. SELECT YOUR VIEWING SOURCEA TV source refers to the equipment connected to the TV thatsupplies the picture and sound to your TV. You select theviewing source by using the SOURCE MENU.To Access SOURCE MENU1. Press SOURCE on the remote control to view theSOURCE MENU.2. Press SOURCE repeatedly until the desired source is high-lighted.3. Press ENTER to return to normal viewing.5DUFIEEIANT/CABLE 1ANT/CABLE 2VIDEO 1VIDEO 2S-VIDEO 1VIDEO 3S-VIDEO 2NOTE: The antenna or cable must be connected to the TV be-fore using AUTO PROGRAM to find available channelsSTEP 3. USE AUTO PROGRAMAUTO PROGRAM finds all available channels and storesthem in the memory of the TV for use by CHANNEL (CH)Up/Down. Use AUTO PROGRAM only when you first in-stall your TV, or when you permanently change the connec-tions to the TV. For example, when you replace the antennawith a cable-TV system.NOTE: AUTO PROGRAM can only be used with ANT/CABLE 1 or 2 Source selection.To Use AUTO PROGRAM1. Press MENU on your remote control repeatedly untilthe SETUP MENU appears.2. Press SELECT (SEL) UP/DOWN to highlight AutoProgram.3. Press ADJUST (ADJ) Left/Right to start Auto Program.4. Use AUTO PROGRAM independently for each AN-TENNA or CABLE signal source connected to yourTV. Select one source by using the SOURCE MENU(AN'I_/CABLE 1 or 2) and use AUTO PROGRAM.When completed, select the other source and useAUTO PROGRAM again.STEP 4. TIME FUNCTIONSSet Clock In TV1. Press Menu until the SETUP MENU is selected.2. Press SELECT (SEL) to highlight CLOCK SET thenuse the number buttons on the remote to enter thecorrect time.3. Select AM or PM using the TIMER key on the remote.4. Press ENTER (ENT) to start the clock._I [AUTO PROGRAM ]CH. ADD/DELCH. LABELSTUNING BANDAUTO TUNINGSOURCE IDCLOCK SETCAPTIONSWhen Some Channels Are Not FoundAUTO PROGRAM finds only active channels and storesthem in the favorite channel memory. You can add channels tothose stored in memory by using CH. ADD/DEL.[ I 10:00AMAUTOPROGRAMCH. ADD/DELCH. LABELSTUNINGBANDAUTOTUNINGSOURCEIDICLOCKSETCAPTIONSSelecting Clock Set(continued on next page)Z_D 2- 1