Zenith Sentry 2 SY2518 Operating Manual & Warranty

Contents

STANDARD CONNECTIONS FOR YOUR TMSETUP 3: TV AND VCRff you receive your television signal through your VCR, connect'our television as follows:Leading from.,CableA "VHF In" (From Antenna)jack of VCR.B&CD ANTENNA/CABLEconnector on TV.E75-ohm cable fromAntenna or cable-TVwall jack.Not required.75-ohm cable fromVCR's "VHF Out" (ToTV) jack.Audio/Video (A/V)cables from "VideoOut," "Audio R Out"and "Audio L Out" jackson the back of VCR.Corresponding "Video,""Audio R" and "Audio L"jacks on the back of theTV.NOTE:Q If your antenna has a flat (300-ohm) wire leading from it, youwill have to attach this wire to a 300-75 ohm adapter before theantenna can be connected to the VCR.SETUP 4: TV WITH VCR AND CABLE BOXIf you receive your television signal through your VCR and cablebox, connect ),our television as follows:A Not required.B 75-ohm cable from cable-TV wall jack.C 75-ohm cable fromoutput connector ofcable box.DE75-ohm cable fromVCR's "VHF Out" (To_) jack.Audio/Video (A/V)cables from "VideoOut," "Audio R Out"and "Audio L Out" jackson the back of VCR.Input connector of cablebox."VHF In" (From Antenna)jack of VCR.ANTENNA/CABLEconnector on TV.Corresponding "Video,""Audio W' and "Audio L"jacks on the back of theTV._BOX BACKSETUP 3 and SETUP 4AFTER YOU HAVE CONNECTED YOUR TV, PLUGTHE POWER CORD INTO AN OUTLET THAT IS NOTCONTROLLED BY A SWITCH.3o48-o 1 _ 2