Zenith Sentry 2 Series Operating Manual & Warranty

Also see for Sentry 2 Series: Operation guide & warranty Operating guide & warranty Operating guide & warranty Operating guide & warranty Operating guide & warranty

Contents

OPERATING YOUR TVBASIC TV OPERATIONS -_Selecting Channels by Using CHANNEL (CH) Up/Down:You may select a channel through channel scanning by usingCHANNEL (CH) Up/Down. Only channels stored in thechannel scan sequence can be selected.Selecting Channels by Using Numbers on Remote (OnSome Models): Press the numbers corresponding to thechannel desired, then press ENTER (ENT). Any channel inthe band chosen can be selected through direct numberentry.FI.,SHBK ff'lashback) on Remote (On Some Models):Press FLSHBK to return to the last TV channel you werewatching.Adjusting Volume: You can adjust the volume of your TVby using VOLUME (VOL) Up/Down.Muting Volume: To mute the sound coming from your TV,press MUTE on the remote control. To restore sound,press MUTE again.Alter an Extended Power Outage: If you previously usedAUTO CH. SEARCH, you do not have to use it again un-less you permanently changed the connections to the TV.All of the channels previously found are stored in protectedmemory, and are not affected by a power outage. However,the clock must be reset to the current time.rCH 2Channel Display(Before Clock is Set)CH 210:56MUTEDChannel/Time DisplayWhile TV is MutedMUTEDCH 210:56Channel/Time Display(After Clock is Set)voLVolume Display *VOL or MUTED display isshown only when captions arenot being dlisplayed.JMute Display *SLEEP TIMER (On Some Models)Some remote controls are equipped with a TIMER buttonthat provides access to the SLEEP TIMER available withsome TV models. By using the SLEEP TIMER, you canprogram the TV to automatically shut off after a periodfrom 15 minutes up to 4 hours.To Set SLEEP TIMER1. Press TIMER to see status display.2. Press TIMER repeatedly until you reach desiredshut-off time.One minute before the TV shuts off, the GOOD NIGHTdisplay appears on the screen. At this time you have achoice of the following three actions.1. Do nothing. The TV will shut off in one minute. Thedisplay will count off the remaining seconds.2. Remove the GOOD NIGHT display by pressingENTER (ENT). The TV will still shut off in oneminute.3. Delay the shut off by ,asing TIMEI; t to select a newshut off time.To Cancel the SLEEP TIMFRYou can cancel the SLEEP TIMER by setting the SLEEPTIMER status to OFF. Press TIMER repeatedly until thestatus show.,; OFF.NOTE: The SLEEP TIMER resets to OFF when you turnoff the TV._ SLEEP TIMER --10:15Sleep Timer Display- SLEIEP TIMER -_GOOD NIGHT0:58"Good Night" DisplayZS_A 3 - 1