Zephyr AK7000BS Use, Care And Installation Manual

Also see for AK7000BS: Use, care and installation guide Use, care and installation guide Use, care and installation guide

Contents

Zephyr AK7000BS Use, Care And Installation Manual Manual pdf 20 page image

18www.zephyronline.comFeatures & Controls – Optional Remote ControlRF REMOTE MAINTENANCE:Clean the remote control using non abrasive detergentsFollow instructions below for replacing battery.Using a small flat head screwdriver, raise the cover of the batterydoor (A) in order to access the battery compartment. FIG. 2.Remove the battery and replace with battery type A23 12V.Negative end of battery should face the spring inside the remote.Re-install battery door and recycle old battery.RF REMOTE FEATURES:The RF remote control is equipped with a magnet on the back for easystorage. The remote may be placed on any magnetic surface such as arefrigerator or the Zephyr remote holder, FIG. 1. The remote holder canbe inserted into a standard electrical outlet for easy storage. Note: Theremote holder does not charge the RF remote.Maximum remote control communication distance is 15 feet from the hood.SYNCHRONIZATION: To create a unique link between your hood and remote control please follow these steps:1. With hood off, press and hold the “lights” button on the hood until the letter “F” shows on the display screen.2. Press the “lights” button on the remote, the lights on the hood will turn on and synchronization is complete.RF REMOTE FUNCTIONS:FIG. 1FIG. 2Blower On / Speed SelectionPress to power on blower and cycle through all six blower speeds.Blower On / Power OffBy pressing , the blowers will power on at the last speed setting. Pressagain and the entire hood will power off, including lights.Delay OffLights On / Dim / OffSwitch lights On by pressing once, again to dim and again to switch Off.Blower On/Speed Selection 11234Blower On/Power Off25 Min Delay Off 3 Lights On/Dim/Off4By pressing , the blower and lights will enter Delay Off mode. A dot willappear in the lower right corner of the hood display indicating the functionis on. The blower will change to speed 1 and shut down after 5 minutes.A -+FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compli-ance could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computeror peripheral device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This devicemay not cause harmful interference, and (2) This device must accept any interference received, including interference that may causeundesired operation.THE RF REMOVE CONTROL IS AN OPTIONALACCESSORY NOT INCLUDED WITH THE HOOD ANDMUST BE PURCHASED SEPARATELY