Zephyr ES1-E30AB Use, Care And Installation Manual

Contents

Zephyr ES1-E30AB Use, Care And Installation Manual Manual pdf 10 page image

- 10 -To remove the blower wheel, firsttake off its intake ring. Then removethe blower wheel by pulling it downsmoothly.HD0156DDo:• Regularly wash surfaces with cleancloth or rag soaked with warm waterand mild soap or liquid dish detergent.• Always clean in the direction of originalpolish lines.• Always rinse well with clear water (2 or 3times) after cleaning. Wipe completely dry.• You may also use a specializedhousehold stainless steel cleaner.Don’t:• Do not use any steel or stainless steelwool or any other scrapers to removestubborn dirt.• Do not use any harsh or abrasivecleansers.• Do not allow dirt to accumulate.• Do not let plaster dust or any otherconstruction residues reach the hood.During construction or renovation,coverthe hood to make sure no dust adheresto stainless steel surface.STAINLESS STEEL CLEANING:NOTE: Do not try to remove the black part (C) attached to the bottompanel.When reinstalling the blower wheel, make sure the small tab (D) will fit into one hole of the motor.10. CLEANING (CONT’D)Avoid: when choosing a detergent- Any cleaners that contain bleach will attack stainless steel.- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol,etc., are highly explosive and should never be used close to a range.E NAMEL FINISH:Clean with warm water and mild detergent only. If discoloration occurs, use a good enamelpolish such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner.)C

/ 13

Related manuals for Zephyr ES1-30AW