Zibro SRE 228 TC Silver Operating Manual

Also see for SRE 228 TC Silver: Operating manual

Contents

Zibro SRE 228 TC Silver Operating Manual Manual pdf 6 page image

MANUALA INSTALLING THE HEATER1 Carefully remove your heater from the box and check the contents.In addition to the heater you also need to have: a manual fuel pump a transportation cap these directions for useKeep the box and the packaging materials (Fig. A) for storage and/ortransportation.2 Open the lid of the removable tank and remove the piece of cardboard.3 Fill the removable tank as indicated in Section B.4 The floor should be firm and completely level. Reposition the heater, when itis not level. Do not try to correct the situation by placing books or othergoods under the heater.5 Insert the plug into the wall-socket (230 Volts - AC / 50 Hz) and set thecorrect time using the adjustment keys (refer to Section C).6 Your heater is now ready for use.B FILLING FUELFill the removable tank in a suitable place since there can always be some spillage.Follow the procedure below:1 Make sure that the heater is switched off.2 Open the upper lid and lift the removable tank out of the heater (Fig. B).Note: Some drops may leak from the tank. Put down the removable tank(cap pointing upwards, handle on floor (Fig. C) and screw off the fuel cap.3 Fill the removable tank using a fuel pump (refer to fuel pump operationinstructions.) Make sure that it is in a higher position than the removable tank(Fig. C). Insert the ribbed hose into the opening of the removable tank.4 Check the removable tank fuel gauge while filling the tank (Fig. D). Stopfilling once the gauge indicates that the tank is full. Never overfill the tank,especially not when the fuel is very cold (fuel expands when it heats up).5 Let the remaining fuel in the pump flow back into the jerrycan and carefullyremove the pump. Carefully screw the fuel cap back on the tank. Clean offany spilled fuel.455 CBDempty fullA