456F: The required tempe-rature on the left, themeasured temperatureon the right.E: When the 4-digit stopsblinking, the setting hasbeen locked to the indi-cated value.+6 Check whether the fuel cap is straight and tightened properly. Reinstall theremovable tank in the heater (cap down). Close the lid.C SETTING THE CLOCKIt is only possible to set the correct time, when the heater is connected to themains and not burning. Use the adjustment keys to set the time. First presseither of the two keys to switch on the function (the 4-digit will start blinking).Next, set the hours using the key on the left (hour) and the minutes using thekey on the right (min.). Press once to increase the value by one step. When youhold down the key, the value will continue going up, until you release the keyagain. After approximately 10 seconds the 4-digit will stop blinking and the set-ting will be locked. 5 minutes after switching off the heater, the information onthe display will disappear and the heater will automatically switch into the stand-by position.When the heater has been unplugged (or after a power failure), the time needsto be set again.D IGNITING THE HEATERWhen used for the first time, a new heater may give out a smell for a short while.You should therefore provide extra ventilation.Always ignite the heater with the button . Never use matches or a cigarettelighter.Just press the button to ignite the heater. The POWER lamp will start blinking,indicating that the ignition procedure has started. This will take a short while. Oncethe heater is burning, the POWER lamp will remain lit (red). The information display will show two numbers. The light next to them indicates that these numbersrefer to the temperatures (Fig. F). The actual room temperature is indicated belowROOM, while the temperature setting is indicated below SET. The latter can bechanged with the adjustment keys (refer to Section E).Prior to igniting the heater, always check for sufficient fuel in the removable tank.E SETTING THE REQUIRED TEMPERATUREThe temperature setting can only be adjusted, when the heater is burning. Usethe adjustment keys to adjust the temperature. First press either of the twokeys to switch on the function (the °C mark will start blinking). Next, adjust thetemperature using the key on the right (min.) to set the temperature to a highersetting and the key on the left (hour) to lower the temperature. Press once toincrease the value one step. After approximately 10 seconds the °C mark will stopblinking and the setting will be locked (Fig. F).The available temperature settings range from 6°C minimum to 28°C maximum.When the heater has been unplugged (or after a power failure), the temperaturewill reset to the factory setting of 20°C.