Zip Chilltap CH103 Installation And Operating Instructions Manual

Also see for Chilltap CH103: Installation and operating instructions

Contents

Zip Chilltap CH103 Installation And Operating Instructions Manual Manual pdf 5 page image

Page 5 of 10 Zip Chill Tap - Installation & Operating Instructions - 82127 - June 2012 v1.03Use a 25 mm sheet metal punch to create a neat hole without burrs.Remove the nut and washer from the base of the carafe filler, leaving therubber-sealing ring in place.Fit the carafe filler and seal to the sink, oriented so that the operating lever is awayfrom the sink bowl.Slide the washer and nut over the tube from under the sink, and tighten the nut tosecure the carafe filler firmly into place.ConnectingInstall the filter following the separate filter kit installation instructions.NOTE: You must separately supply and install an isolating valve in the supply linebefore the connection to the product.If the pressure exceeds 0.7 MPa (7 bar), a pressure reducer will be required. AQ3 isavailable as an option (see options table page 4).From the outlet of the filter housing connect the tube to the JG fitting marked INLETon the top right rear of the chiller unit, trim to length before fitting.Make sure all connections to John Guest fittings are pushed in past the O-ring tofull depth, at least 15-16mm (see diagrams on left).Now measure and cut the tube from the Carafe filler, slide on the insulationprovided and connect to the JG fitting marked OUTLET on the top left rear of thechiller.Tap connection is now complete.PrecautionsThe plumbing installation must be done in accordance with local Water Authorityregulations and these Installation Instructions.As the installer, it is your responsibility to supply (if necessary) and install all valvesas required by local regulations and relevant standards.The chiller and filtration systems are indoor units and must not be exposed to theelements.Take care, when bending rigid plastic tubing, to prevent it from kinking or crushingaround a bend. As it is plastic tubing containing water under mains pressure, becareful not to nick, scratch or damage it during installation.Cut the tube squarely with a sharp knife or tube cutter. Shake out and remove anyswarf and debris.Installation InstructionsInstalling the ChillerSite the chiller unit into the cupboard as close to the proposed outlet tap positionas is possible to minimise the length of tubing exposed between the chiller unitand the outlet tap.Allow at least 50mm around the chiller unit to permit free airflow. Both the top andthe front of the chiller must remain accessible for servicing purposes.Installing the TapInstall the carafe filler at the back of the sink where there is a 45 mm wide flatarea within the draining area of the sink.Make sure the selected position allows the carafe filler spout to overhang the sinkbowl.John Guest Fittings