Zip Chilltap CH103 Installation And Operating Instructions Manual

Also see for Chilltap CH103: Installation and operating instructions

Contents

Zip Chilltap CH103 Installation And Operating Instructions Manual Manual pdf 6 page image

Zip Chill Tap - Installation & Operating Instructions - 82127 - June 2012 v1.03 Page 6 of 10Ensure there is adequate ventilation available through the cupboard. If thereis inadequate ventilation, and the cupboard temperature rises to above 40°C,the chiller may become damaged and malfunction which will void the productwarranty.There must be a minimum 168 cm2 of cupboard cross-flow ventilation.Suitable holes or vents will need to be cut into the cupboard and door.For safe operation, thoroughly flush the water through after non-use periodslonger than 12 hours.Filter cartridges should be replaced at least every 6-12 months, or sooner ifyou notice:A. a persistent reduction in water pressure from the product, or;B. an unpleasant taste or odour in the water.Not changing the cartridges when required may cause the water to becomebiologically unsafe.ElectricalElectrical connection is to be made by a Zip Service Engineer or a qualifiedelectrician.Appliance to be wired to a double pole switched fused spur with a minimumbreaking capacity of 13 amps.The supply flex must be securely fixed to the clamp provided within the unit.The connection point is behind the front cover.Installation must comply with current IEE regulations and any Local Authorityrequirements.This appliance must be earthed.DO NOT turn the electric supply ‘ON’ until the unit is purged (seecommissioning below).Installation Instructions continuedOperating ProceduresCommissioningOperationChilled water is obtained by pressing the lever on the carafe filler. The water ischilled by a refrigeration unit fitted within the cabinet, under the basin.With the carafe filler, you can obtain chilled water within the rated capacity foras long as you press down the lever or for longer periods by lifting the lever upuntil it clicks and stays open. Flip it back down to stop the water flow.CommissioningClip the tubing in the cupboard. After the appliance is installed and connected,turn “ON” the water supply. Check all connections for leaks. Repair any found.The filters, chiller and tubing are full of air until purged. Press the operatinglever on the appliance outlet tap for a minimum of five minutes until all of theair has been purged from the system.Wipe clean and dry the area.Dispose of packaging wisely.