abi KINGSLEY 14629 Assembly

abi KINGSLEY 14629 Assembly Manual pdf 1 page image

SPECIFICATIONSRECOMMENDED USECONSTRUCTIONDisclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right tovary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI andthe manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2021.Note: Dimensions are nominal measurements onlyINSTALLATION GUIDENote: This product must be installed by a licensed plumber.This is a general installation guide - there are many factors that are involved that canalter the installation method. This product install must comply with AS/NZS 3500.DomesticSolid BrassNote: In wall not included in handle kit.Note: In wall not included in handle kitTop ViewFront ViewNote: Dimensions are nominal measurements only78 25541426 13 3574New Build - Install breach in desired position (please refer to additional install information regarding breach set backs).Retrofitting Existing - Remove existing tapware & reseat body seats until shiny and smooth.DO NO T use creamcleaners or bleach.These sub stances a reabrasiveDO NO T use cle aningpads with ab rasivesur faces as this ma yscratch the mate rialRegularly c lean withmild liq uid det ergentor soap and wa terRemove locking nut from spindle. Screw spindle into breach and handtighten until rear of spindle meets the body seat, be sure not to overtighten.If necessary apply more pressure lightly with spanner.Fit the fibre washer over the spindle. Screw on the locking nut andtighten with spanner. TEST AND CHECK FOR LEAKS.1 2This product may require a bonnet extender (purchase at local hardwarestore) that may be required to cover the additional breach depth. Pleaserefer to the following page for breach set back guide. If required, screwbonnet extender on to locking nut.3 Install the back plate onto the locking nut (or bonnet extender ifrequired), twisting by hand until tightened.4A 10mm brass spacer is provided to achieve optimum handle spacingfrom the back plate. Insert spacer into rear side of handle and installhandle onto spindle, fixing with a screw and washer.5 Insert handle cap into front of handle.6Note: Bonnet extendernot included with assembly taps.Available at local hardware store.KINGSLEY ASSEMBLY HANDLE KIT

/ 2

Related manuals for abi KINGSLEY 14629