|
®Operating Functions Section 3DriveRack ™PA19DriveRack™ PA User Manual - is used to navigate back through the various pages of any module block. - is used to navigate forward through the various pages of any module block. - is used to move to the EQ modules. Successive presses will move you through theEQ modules in the input section and through EQ modules located in the output section. - This button is used to move to the Subharmonic Synthesizer module. - is used to move to the Crossover module. - is used to move to the feedback elimination module. - is used to move to the Compressor or Limiter modules. - is used to move to the Delay module. - is used to enter program mode when pressed. - is used to access the the Utility menu. - is used to store any program changes. - is used to enter the Wizard section which includes: SYSTEM SETUP, AUTO EQWIZARD and AFS WIZARD.Once you have reached the module that you wish to edit, simply use the and buttons to move through the pages within the module. The wheel is used to edit parameter values. The following illustration shows anexample of the Comp module in edit mode:Note that the arrow indicates the currently selected parameter for editing. To selectparameters to edit from the current page, simply press the wheel until thearrow is pointing to the parameter that you wish to edit.Once you are satisfied with the changes that have been made to a factory or user pro-gram, the DriveRack™ allows you to save these changes as a custom USER program bypressing the button, and the display will appear as follows:DATA - SELECTS CHARPREV/NEXTPG - LEFT/RIGHT:PRESS STORE TO ADVANCENAME: ROCK VENUEOver Easy OFFCompressor ONCOMP THR -50 -30 -12 -5 0LR -0+3.3 Editing Factory Programs
PreviousNext |