dbx DriveRack User Manual
Also see for DriveRack: Monitor application guideUser manualUser manual
                                                   | |
Contents
| 
®Analog Inputs:Number of Inputs: (2) Line inputs. (1) RTA Mic inputConnectors: (2) Female XLR line inputs, XLR RTA Mic inputType: Electronically balanced/RF filteredImpedance: > 40k ΩMax input line level: +20dBuCMRR: > 45dBRTA Mic Phantom Voltage: +15VDCRTA Mic EIN: < -117dBu, 22Hz-22kHz, 150ΩAnalog Outputs:Number of Outputs: (6) Line OutputsConnectors: Male XLRType: Electronically balanced, RF filteredImpedance: 120 ohmsMax Output Level: +20dBuAlignment Delay: 10ms per channel (60ms total)A/D Performance:Type: dbx Type IV conversion systemDynamic Range: >107 dB unweighted, >110 dB A-weightedType IV dynamic range: 123 dB with transient material, A-weighted, 22kHz BW 121 dB with transient material, unweighted, 22kHz BW 115dB typical with program material, A-weighted, 22kHz BWSample Rate: 48kHzD/A Performance:Dynamic Range: 112 dB A-weighted, 110dB unweightedSystem Performance:Dynamic Range: 110 dB unweighted, >107dB weighted,THD+N: 0.002% typical at +4dBu, 1kHz, 0dB input gainFrequency Response: 20Hz – 20kHz, +/- 0.5dBInterchannel Crosstalk: >110dB, 120dB typicalCrosstalk input to output: >100dBPower Supply:Operating Voltage: DO: 100-120VAC 50/60 Hz - EU: 220-240 VAC 56/60 Hz,Power Requirements: 25 WattsPhysical:Weight: 5.5 lbs.(2.5 kg) Shipping weight 7 lbs. (3.18 kg)Dimensions: 1.75” H x 5.75” D x 19” WBy using the setup wizard, cross over output gains and post cross over parametric EQ settingsare set to match your system. The Auto-EQ can be used to adjust your system to compensatefor room effects, and adjust the response of the entire system to your liking. After allowingAuto EQ to “pink the room” your system will sound tighter. The low end will have more def-inition, the mids will be more intelligible, and the highs can be tamed. Here are two things tolook for to get the best performance from the Auto-EQ.Look out for ModesSome speaker and RTA microphone positions will result in certain frequencies canceling out.The resulting modes can not be corrected with equalization. The Auto-EQ does not detectmodes in the frequency response, so may try to boost a band to compensate for a mode withA.4 Auto EQ Optimization TipsA.3 SpecificationsAppendix ADriveRack™ PA User Manual 37DriveRack ™PA |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine