halstrup-walcher KAL 100 Instruction Manual
Also see for KAL 100: Instruction manual
                            | |
Contents
| 
Instruction Manual KAL 100/200811 12 13Fig. 3 Rear10 USB port11 Inlet connector for non-heating apparatus12 Micro fuse, 315 mAT, 5 x 20 mm13 Primary on/off switch14 Power supply +24V/125mA, galvanic separation15 Ground for 24V/125mA16 Input port for current measurement 0…20 mA,input resistance 240 Ohm17 Ground connector for voltage and current inputport18 Voltage input 0…10V, Ri = approx. 40kOhm4.2.1 Power input, primary on/off switch, micro fuseThe KAL 200 calibration device is designed at the factory toaccommodate a supply voltage of 230 VAC/50-60 Hz (115 VAC/50-60Hz is optional). Voltage fluctuations of +6% to -15% are permissible.The supply voltage connector (11) is located on the rear of theinstrument (inlet connector for non-heating apparatus + ground wire).The instrument’s micro fuse (12) is located above this connector. Value:315 mAT; dimensions: 5 x 20 mm. Located above the micro fuse is thedouble-pole, primary on/off switch (13), which separates the KAL 200from the supply voltage.WARNING! Risk of Electrical shock! Failure to unplug the power supply cordbefore replacing the fuse may result in fatal injuries!10 1415161718111312 |
Related manuals for halstrup-walcher KAL 100
manualsdatabase
Your AI-powered manual search engine