iDirect iNFINITI 3000 Installation And Commissioning Manual

Contents

iDirect iNFINITI 3000 Installation And Commissioning Manual Manual pdf 45 page image

41iDirect iNFINITI series Installation and Commissioning Guide, Release 7.010 Record the Geo Location - Mobile Secure Remotes OnlyIf for security reasons the Satellite Router’s geographic location coordinates have not beenrecorded by the Network Help Desk, you must enter these coordinates into the Satellite Routermanually, before the modem will acquire into the network.10.1 Set the Satellite Router’s Geo LocationYou will enter the latitude and longitude coordinates from the Satellite Router console via a specialcommand.10.2 Verify the Satellite Router’s Geo LocationYou should verify that you have entered the correct geographic location coordinates.NOTEThis section describes a specific operational scenario forconfiguring remote Satellite Routers as both Mobile and Secure. Ifyour remotes do not fall into this category, skip this section.WARNINGIt is critical that the geographic coordinates accurately reflect yourcurrent geographic location. If the values are incorrect, yourSatellite Router will not be acquired into the network.1. Open a HyperTerminal session on the Satellite Router’s console. Alternatively,you may telnet to the Satellite Router.2. At the prompt, type the following commandlatlong [N|S] [E|W]Format of the latlong CommandThe format of the latlong command is: latlong [N/S] [E/W]When entering this command, replace the string with your current latitude in decimalnotation, followed by N for north or S for south. Replace the string with your currentlongitude in decimal notation, followed by E for east or W for west.1. Type “ extras show ” at the console prompt to display the current settingsfor latitude and longitude.2. Reset the Satellite Router.