202.2. Loading the cardsThis section shows how to load the plastic cards.Pic.19 Adjusting the card thickness lever2.2.1. Open the input hopper cover.2.2.2. Adjust the card thickness with thecard thickness control lever.(Caution! If the adjustment is not correct, it willmake some error. Use the type of cards in thespecification of this manual. Always keep thecard surface clean state.)Pic.20 Preparing the card 1Pic.21 Preparing the card 22.2.4. To separate cards from each other,push a stack of cards back andforth to an angle about 45 degreesvertically.(Static charge makes cards stuck withsignificant adhesive force. These cards must bephysically separated from each other beforeinserted into the feeder. If not separated,feeding or printing problems may occur.)