31Clean periodicallyMaintenanceBefore carrying out maintenance or storage, always allow the equipment to cool.- Clean the station screen with a glass cleaneror a damp cloth.1. Pull off the fuse holder and remove thefuse. If necessary use a tool to lever it off.2. Press the new fuse into the fuse holderand replace it in the station.- Use a damp cloth to clean the casing andthe tool. Alcohol can only be used to cleanthe metal parts.- Periodically check that the metal parts ofthe tool and stand are clean so that thestation can detect the tool status.Fuse holderFuse holder- Maintain tip surface clean and tinned priorto storage in order to avoid tip oxidation.Rusty and dirty surfaces reduce heattransfer to the solder joint.- Periodically check all cables and tubes.Fuse- Replace a blown fuse as follows:- Replace any defective or damaged pieces. Use original JBC spare parts only.- Repairs should only be performed by a JBC authorized technical service.www.jbctools.com