lancer 4400 Series Operation Manual

Also see for FLAVOR SELECT 22: Installation and service manual

lancer 4400 Series Operation Manual Manual pdf 18 page image

3.6 ICE BIN CLEANINg - pERFORM AT STARTUp AND MONTHLY - CONTINUEDF. Remove Dispensing Wheel Shroud.WHITE WHEEL SHROUD (pELLET ICE) BLACK WHEEL SHROUD (CUBED ICE)G. Remove Splash Plate Assembly by lifting it up and out from the dispenser face.H. Use the Cleaning Solution described in Section 3.1, and a clean cloth or soft brush, to clean allremovable parts, sides of Ice Bin, Ice Chute, and surface of aluminum casting.I. Repeat Step H for all exterior surfaces of the dispenser.J. Using hot water, thoroughly rinse away the cleaning solution.K. Wearing sanitary gloves, soak a clean cloth towel in Sanitizing Solution, described in Section 3.2,and wash all surfaces of removable parts, sides of Ice Bin, Ice Chute, and surface of aluminumcasting.L. Repeat Step I for all metal and plastic surfaces (not labels) of the dispenser exterior.M. Wearing sanitary gloves, reassemble all removable parts. Ensure agitator clip is locked (See Fig 2,Section 1.2).N. Fill Unit with ice and replace Top Cover.O. Reconnect Dispenser to power source.3.7 CLEANINg AND SANITIZINg BEvERAgE COMpONENTS - BAg-IN-BOX SYSTEMSNOTE: Extended lengths of product lines may require more time for flushing and rinsing lines thandescribed below.A. Disconnect the syrup quick disconnect coupling from the syrup packages and connect thecoupling to a bag valve removed from an empty Bag-in-Box (BIB) package.B. Place the syrup inlet line in a clean container filled with clean, potable, room temperature water.Activate the valve until water is dispensed. Flush and rinse the line and fittings for a minimumof sixty seconds to remove all traces of residual product.C. Make the sanitizing solution. Place the syrup inlet line in a container filled with sanitizingsolution.IBD 4500/4600/LCD181. Remove the gasket which secures theshroud by pulling it out.2. Push the front section of the shroud back.3. Pull the shroud up and out.4. Remove the lower ice chute assembly.1. Remove the dispensing wheel shroud.2. Remove the lower ice chute assembly.CONTINUED ON NEXT PAGE