lancer FLAVOR SELECT 22 Installation And Service Manual

Also see for FLAVOR SELECT 22: Operation manual

lancer FLAVOR SELECT 22 Installation And Service Manual Manual pdf 24 page image

1. Bonus Flavorsa. Decide if the bonus flavors will be set to add an injected flavor to thebrands or dispense carbonated water/plain water.b. Choose the Valve number (1-2) by scrolling UP and DOWN arrows.c. Use the LEFT and RIGHT arrows to shift to the Top, Middle, or Bottom"bonus" flavors categories.d. Press the UP and DOWN arrows under Top, Middle, or Bottom to selectit as an injected flavor, carbonated Soda water, or plain Water.e. Press ENTER to finalize settings. Panel lights should confirm finalizedconfigurations.2. Brandsa. Decide how the brands will be setup.b. Choose the Valve number (1-2) by scrolling UP and DOWN arrows.c. Use the LEFT and RIGHT arrows to shift to the Left or Right categories.The Left or Right categories are set with the assumption that youare looking at them from the front.d. Press UP and DOWN arrows under Left (1-2) or Right (1-2) to select thebrand per side as a single or double. For example, for bezel PN 05-2120,V:1 L:1 R:23. Soda/Watera. Decide which switch locations will be carbonated and/or non-carbonateddrinks.b. Choose the Valve number (2-3) by scrolling the UP and DOWN arrows.c. Use the LEFT and RIGHT arrows to shift to the number categories (1-4).The number categories correspond to the brand location (per valve)that is being configured.d. Press the UP and DOWN arrows under the number to select if that brandwill be carbonated Soda or non-carbonated plain Water. If a single brandper side, only number 1 and/or 3 need to be set.4. Automatic Agitationa. Each Series 14400 ice beverage dispenser is equipped with automaticagitation for the ice bin. The unit is shipped with timing set at two seconds(2000 milliseconds) ON every sixty minutes for cubed ice. The unit isshipped with timing set at four seconds (4000 milliseconds) ON every150 minutes for pellet ice.3.3 PURGING THE CARBONATION SYSTEMPurge the carbonator tank whenever carbonation issues occur.A. Turn off CO2 supply.B. Turn off power to the unit. Unplug the carbonator harness from the powersupply.C. Open the relief valve until water is coming out. Close the relief valve, checkingfor any remaining air in the tank.D. Allow the carbonator tank to fill with plain water by way of the water booster.24P.N. 28-0580/02