mangOH Red Manual
Also see for Red: User guideUser guideGetting startedGetting started guide
                                                            | |
Contents
| 
Rev 3 9/21/17 933: Set Up Your mangOH Red HardwareIn this chapter, you will set up your mangOH Red to begin developing applications.A typical mangOH Red kit includes:• mangOH Red board• Pre-installed CF3 (Common Form Factor) module and cover, and release tool• micro-USB cables (2)• Antenna (main)• Antenna (diversity)—Included if the CF3 module supports LTE• Sierra Wireless micro-SIMThe following image summarizes the parts of the mangOH Red that you will set up when you follow theinstructions in Hardware Setup on page 10.Important: Do not start connecting components until told to in the instructions, otherwise you mayencounter problems later in the guide.Connect CF3 USB porton bottom side of boardOptionally, connect CONSOLE USBSet jumper on PowerHeader to select USBInsert Sierra Wireless (or other) SIM cardin slot on bottom side of board to connectSet dipswitches to properOptionally, attach thediversity antennaAttach themain antenna topositions for the tasks inthis guide.to dev machine forpower and to log in tothe device.port used for inputpower supply.port to dev machine to displaydiagnostic messages.be able to connect toa mobile network.for modules thatsupport Rx diversityto a mobile network.(connector besideheader pins) |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine