9Technical InformationSpecificationsSoundStories 6Speaker Compensation multi-band parametric EQAudio Input Jack 3.5 mm stereoPower Requirements 5 Volts, 500 mA, DCProduct Dimensions 5.37" x 4.62" x 2.55"How to Restore Factory SettingsTurn the nomad unit Off. Remove batteries if installed. Connect the PowerAdapter and Power Cable. Turn nomad On. Wait a few seconds, then pressand hold the Power Button down again until the SoundStory lights flash(approximately 2 seconds), then release the Power Button.Trouble ShootingIf your unit exhibits a problem, try the actions below to resolve the problem.SYMPTOM POSSIBLE CAUSE SOLUTIONDisconnected PowerCableCheck the power connection on the rightside of the nomad unit and at the PowerAdapter. Both ends of the cable must befirmly seated.Faulty wall outlet Try another un-switched wall outlet.Batteries are dead or tooweak to operate nomadReplace batteries and power on again(use of Power Cable is optional).No operation whenpower switch ispressedNo batteries installed Install new batteries.Volume is set too low Press or hold Volume Up button down toincrease nomad volume level.Unit is On, but nosoundSystem is in ExternalAudio Mode but has noaudio input signalProvide audio input signal, or disconnectthe Audio Cable from the Audio InputJack to switch to Internal Audio Mode.Adaptive lightflashing repeatedlyBatteries are dead Remove Power Cable and remove deadbatteries. Insert new batteries.Unit goes On brieflybut then goes OffBatteries are very weak Replace batteries or use Power Cable(see Power Options on previous page)Other unexpectedbehaviorTry the “factory reset”procedure1) Remove batteries2) Plug Power Adapter into an AC outletand connect Power Cable3) Press and hold the Richness Button4) Press the Power Button5) Release Power Button6) Release Richness ButtonCustomer SupportIf you have problems or questions, please contact Adaptive SoundTechnologies, Inc. at 1-408-377-3411 or email support@soundofsleep.com