norxe P1 User Manual
Also see for P1: Communication User Guide
                                        | |
Contents
| 
© All Rights Reservedwww.norxe.comP1 User GuidePage 31 of 4016.66 ms8.33 ms 8.33 msVideo Frame 2Video Frame 1NOTE! - Failure to Sync / Genlock the IG’s properly may result in on screen image artefacts orthe image not being displayed at all.Recommended projector setup / workflow procedure is as follows:• Select DVI-1 as Source.• Go to the Installation menu and select 2560x800@120 as Edid for both DVI-1 and DVI-2.• Go to Picture menu and select Dual input mode – Top/bottom.• Select DVI-1&2 as Source.Video frame/video timing information is as illustrated below:Video output resolution is 2560x1600@120Hz.10.1.3 3D (Active) InputThe projector accepts two separate video inputs. One containing left eye information, the othercontaining right eye information.• Projector DVI-1 is the left eye video input, whilst projector DVI-2 is right eye video input or viceversa.• Projector video input resolution must be 1920x1200@60 for P1 WUXGA projector modelvariants and 2560x1600@60Hz for P1 WQXGA projector model variants on each input.• Image Generator (IG) outputs must be synchronous (see illustrations Fig. 1 & Fig. 2 overleaf forfurther guidance):DVI-2(Input Resolution:2560x800@120Hz)DVI-2(Input Resolution:2560x800@120Hz)DVI-1(Input Resolution:2560x800@120Hz)DVI-1(Input Resolution:2560x800@120Hz) |
Related manuals for norxe P1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine