7. Programming - tests - information:Press the ‘ENTER’ button. The Display shows:Then press the‘1’ key four times: The Display shows:And we have entered in the technician menu.After this we can conduct a full systems check, we can modify the configuration of thesystem, we can see the various voltages in different stages of the system, we can alsoactivate or deactivate the various options. The deletion of the history record and themodification of the user and technician codes can also be done in this level of operation.Level 3 operation are operation the change the default factory settings of the system. For asimple fire detection installation without any special requirement, there is no need forany changes and the system can operate with the factory settings. It is mandatory to enterthis level only if the installation requires special operations or settings.In order to enter level 3 programming mode the technician code(service code) is required. Thisis preset to <1111> but can be changed to any other 4-digit code. In order to access level 3operations follow the procedure described bellowENTER YOUR CODE----SELECT->ENTERSYSTEM CHECK *SELECT->ENTERTEST *TEST MODEWALK TESTACTIVATE 60:00ZONE ONE BY ONEWhen the system is in this state it can beactivated by an alarm in any zone. It activates thesirens for 2 seconds and then deactivates themautomatically.Sequentially the technician can test the required zones by activating adetector or call point. To exit this mode press the‘ESC’ key. This mode willalso be exited when the time shown on the Display has elapsed.RESETZONES OF PANEL 1setting ‘2=RESET’ starts to blink. Pressing the ‘ 1’ key reactivates all thezones.PANEL ZONES 11=ACTIVE 2=RESETWhen ‘ENTER’ is pressed the Display shows:The setting ‘1=ACTIVE’ blinks.In this state the technician can conduct a full systems check . When the‘ENTER’ key is pressed the Display shows:7.1 TestsThe first selection of the technician menu is If we press the‘ENTER’12 from 21921116000DateFileCodePage921116000_09_01613/03/2013