11Installation InstructionS1 ONS2 OFFS3 ONEnter double Master door withsynchronised door motion.S1 OFFS2 OFFS3 ONEnter double Slave door withsynchronised door motion.Double wing Master - Slave selectionS1 ONS2 ONS3 OFFSingle setting wingMultislave (address 3)S1 OFFS2 ONS3 OFFSingle setting wingMultislave (address 2)Single wing Multislave selectionS3 ONDouble-wing operation.This option should be selec-ted only in the case of two SWIN-GY automatisms connectedtogether for the opening of a two-wing entrance.S3 OFF (DEFAULT)Single-wing operation.Number Wing SelectionS1 ONS2 OFFS3 OFFSingle setting wingMultislave (address 1)S1 OFFS2 OFFS3 OFFSingle setting wing NOMultislave (DEFAULT)“Low Power” mode SelectionThe SWINGY operation can be set in "low power" mode, which provides for reduced operating speeds and accelerations.S4 ON"low power" modeS4 OFF (DEFAULT)Normal modeS1 ONS2 ONS3 ONEnter double Master door.If asynchronous it is the first toopen and the last to close.S1 OFFS2 ONS3 ONEnter double Slave door.If asynchronous it is the last toopen and the first to close.Synchronised door motionAsynchronous door motionA single selector can be connected andextended to several SWINGY automatismsusing two different operation logics:- DEFAULT: the selector acts on all the auto-matisms connected to it without any distinc-tion. For example, if the selector is used toset the Stop Open logic, all the automatismsconnected to it will work with the Stop Openlogic.- MULTISLAVE: with this logic up to 3 auto-matisms can be connected, each identifiedwith a different address to be set as indicatedbelow. The selector can act on each of thethree automatisms in a completely indepen-dent manner.The Multislave logic is NOT available for double SWINGY.In the double SWINGY, it is necessary to set a Master card and a Slave card. The two cards must NEVER be set both as Master orboth as SlaveIndirizzo1Indirizzo2Indirizzo3LOGICAM ULTISLAVEQKSW80