Dell POWER VAULT 130T LIBRARY 130T manuals
POWER VAULT 130T LIBRARY 130T
Table of contents
POWER VAULT 130T LIBRARY 130T
Table of contents
- about this guide
- other documents you may need
- safety warnings
- safety guidelines
- protecting against electrostatic discharge
- power requirements
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Equipment Description
- Description of the PowerVault 130T Library
- Storage Cell Locations
- Operator Panel
- Unpacking and Installation
- Rack Guidelines
- Exterior Packing of the Library
- Unpacking the PowerVault 130T Interior
- Interior Packing of the Library
- Inspecting the PowerVault 130T
- Example of External SCSI Cabling- 2 and 4 drive Configurations
- Connecting the External AC Power Cable
- Location of AC Power Receptacle
- Preparing the Library for Use
- Powering On the PowerVault 130T
- PowerVault 130T Rear View Showing Power Switch
- Chapter 3 Operating the PowerVault 130T
- Operator Panel Controls
- Menus and Displays
- Main Menu
- Library Utilities
- View Configuration
- Set Configuration
- Drive Utilities
- Using the Removable Cartridge Magazine
- Replacing the Five-Cell Cartridge Magazine
- Manual Operations
- Cleaning Tape Drives
- Moving the hand/camera assembly manually
- Retracting the Picker Assembly
- Removing a Cartridge from the Hand
- Removing/Replacing a Cartridge in the Storage Cells
- Mounting a Cartridge into a Drive
- DLT Drive Closed/Open
- Dismounting a Cartridge from a Drive
- DLT Drive Light Emitting Diodes (LEDs)
- DLT DRive LEDs (right front panel)
- Handling Cartridge Tapes
- Applying Cartridge Labels
- Setting Cartridge Write Protection
- Storing Cartridges
- Removing the DLT Drive Tray Assembly
- Interface Connection and Power
- Replacing the Tape Drive Tray assembly
- Connecting the SCSI cable
- Supporting Information
- Reliability
- Environmental Specifications
- Regulatory Notices
- FCC Notices (U.S. Only)
- IC Notice (Canada Only)
- VCCI Notice (Japan Only)
- Warranties and Return Policy
- Coverage During Years Two and Three
- Total Satisfaction" return Policy (U.S. and Canada Only)
- Glossary
POWER VAULT 130T LIBRARY 130T
Table of contents
POWER VAULT 130T LIBRARY 130T
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Specifications
- related publications
- lifting techniques
- General Information
- Component Locations
- Figure 1–3. Rear View of the PowerVault 130T Library
- Robot
- Cartridge Access Port
- Removable Five-Cell Magazine
- Microcode
- Table 1–1. DLT4000/DLT7000 Comparison
- Chapter 2 TIPs, Diagnostics, and Procedures
- TIP 0000: START
- TIP 1000: Power
- TIP 1010: Library Power Problems
- TIP 1020: Tape Drive
- TIP 2000: Operator Panel
- TIP 3000: SCSI Interface
- Library Diagnostics
- Important Procedures
- Setting Tape Drive SCSI IDs
- Setting the Library SCSI ID
- Cleaning Tape Drives
- Chapter 3 Removal and Replacement
- Powering On and Off the Library
- Removing the Front Door
- Required Tools
- CYC Card
- CYO Card
- DLT Drive Tray Assembly
- Electronics Module
- Figure 3–7. Electronics Module (and CYC card) showing Cable Locations
- Figure 3–8. Electronics Module Shown Removed from Library
- Hand/Camera Assembly
- Theta Motor
- Figure 3–11. Z Motor
- Check-Out Procedures
- specifications
manualsdatabase
Your AI-powered manual search engine