PAC STORAGE PS 3012 manuals
PS 3012
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Safety Precautions
- Important Notice
- About this Manual
- Introduction
- Major Components
- Power Supply Unit with Built-in Cooling Module
- Single Controller Models
- Front Panel
- Rear Panel
- Internal Backplane
- Drive Tray Bezel
- Controller Module of Expansion Enclosures
- Super Capacitor & Flash Backup Module
- PSU & Cooling Module
- Expansion Enclosure Status Monitoring
- Hot-Swapping
- Installation Procedures Overview
- Pre-installed Components
- SAS Interface
- Hard Drive Designation
- Installing the Hard Drive into Drive Tray (PS 3025 excluded)
- Installing the Drive Tray into the Enclosure
- Installing Host Boards
- Removing the Controller
- Host-Side Topologies
- Maximum Concurrent Host LUN Connection ("Nexus" in SCSI)
- Fibre-Host Topologies
- Fibre Cabling
- Simple End-to-End Connection
- Switched Fabric Connection (Dual Controller)
- Switched Fabric Connection (Single Controller)
- SAS-Host Connections
- DAS (Direct-Attached Storage) Connection with Redundant Host Path
- DAS (Direct-Attached Storage) Connection to Two Servers
- Network & Host Connection Topologies
- High Availability IP SAN with Redundant Controller
- Single Controller with Fault-Tolerant Path
- High Availability IP SAN (Recommended Cabling Method for Remote Replication)
- High Availability IP SAN with Port Trunk (Remote Replication Enabled)
- Hybrid Host Connections
- Utilizing Hybrid iSCSI Ports for Data Replication
- SAS Expansion Enclosure Configuration
- Dual Controller Expansion Connection
- Single Controller Expansion Connection
- Management Console Connections
- Power Cords Connection
- Power On Status Check
- System Monitoring
- Drive Tray LED
- Unified Storage System Controller LEDs
- G Ethernet Management Port LEDs
- G SAS Expansion Port LEDs
- G Fibre Channel Port LEDs
- Converged Host Board
- Controller LED for 12G SAS Expansion Enclosure Models
- PSU & Built-in Cooling Module LEDs
- System Maintenance
- Restoring Default Settings
- Replacing the Host Board
- Replacing Memory Module(s)
- Supercapacitor Fault Conditions and Precautions
- Replacing Flash Backup Module
- Detecting a Failed PSU
- Replacing Hard Drive
- Replacing Hard Drive for PS 3025 only
- Slide Rail Kit Installation Guide
- Slide Rail Kits
- Tools Required
- Installation Procedure
- Slide Rail Kit
- Once Mounted
- Safety Reminders
- Appendix
- Power Supply
- Environment
Related products
PS 3012 G3PS 3016PSe 3012 G3PS 3012S G3PS 3012R G3PS 3016 G3PS 3025PS 3016R G3PS 3016S G3PS 3024 G3PAC STORAGE categories
More PAC STORAGE categoriesmanualsdatabase
Your AI-powered manual search engine