Disable a Fast Ethernet Port 6-5Disable a FastEthernet PortDisable or enable the Admin status of a Fast Ethernet port (see “FastEthernet Ports” on page 11-5 for general information about Ethernetports).ExampleEnter: [2] [2] 4 UEthernet Port 4 is enabled.The following message is displayed on the screen:Context #0 Event: Ethernet port #4 is Link UpDisplay BroadcastThrottlingAttributesDisplays broadcast throttling attributes. Broadcast throttling can be setfor each port. When the number of broadcast frames through the portexceeds the high threshold, frames are discarded. When the number ofbroadcast frames goes below the low threshold the frames are retained.Table 6-5 Task ActionsMenuSequence Enter Result[2] ethernet[2] status1 Ethernet port number {1-4}2 U(p)/D(own)Administrative Status of Port isenabled or disabledTable 6-6 Task ActionsMenuSequence Enter Result[2] ethernet[3] bcast[1] displayNone Broadcast throttling attributes aredisplayedTable 6-7 Broadcast Throttling AttributesName DescriptionHigh threshold The broadcast transmission rate limit above which broadcastframes are discarded (in frames/second).Low threshold The broadcast transmission rate limit below which broadcastframes are not discarded (in frames/second).abtthgde.book Page 5 Tuesday, June 23, 1998 10:29 AM
