Configuring Port Settings 61■ Link Type – Choose between Point-to-Point,Shared, or Auto for the link type.■ Path Cost – The path cost is used todetermine the best path between devices.The path cost method is used to determinethe range of values that can be assigned toeach interface.■ Port Priority – Used in selecting the rootdevice, root port, and designated port. Thedevice with the highest priority becomes theSTA root device. However, if all devices havethe same priority, the device with the lowestMAC address will then become the rootdevice.If you modify any of these settings, click Applyto save your changes.Figure 48 Spanning Tree Setup ScreenPort MirroringThe Switch allows you to monitor traffic goingin and out of a particular port. For trafficmonitoring to work, you need to attach anetwork analyzer to one port and use it tomonitor the traffic of other ports in the stack.To set up traffic monitoring, you need to set ananalysis port (the port that is connected to theanalyzer), and a monitor port (the port that isto be monitored). Once the pair is defined, andyou enable traffic monitoring, the Switch takesall the traffic going in and out of the monitorport and copies it to the analysis port.CAUTION: The analyzer port should have ahigher bandwidth than the mirror port.Otherwise, the Switch may not be able to copyall traffic effectively during periods of hightraffic.