3Com EtherLink 3C590 User Manual
                                                                            | |
Contents
| 
3-10 CHAPTER 3: INSTALLING THE NETWORK DRIVERSMultiple Adapters in a ServerIf you are running NetWare and have installed multipleadapters in a PCI computer that is functioning as a server,follow the instructions in this section.The 3C59X EtherDisk diskette contains a NetWare 4.x serverdriver (3C59X.LAN) and the NetWare Loadable Modules(NLMs) that enable the NetWare 4.x driver to be used withNetWare 3.11 or 3.12 software. These files are found in the\NETWARE subdirectory.Driver Installation with NetWare 3.11To install the 4.x server driver while running NetWare 3.11,follow these steps:1 Copy the contents of the appropriate \NETWARE subdirectoryto the boot partition of the server’s hard disk.2 When you start the server, enter the following commands:load C:LSLENH.NLM [Enter]load C:3C59X.LAN PORT=XXXX NAME=X [Enter]load C:3C59X.LAN PORT=XXXX NAME=Y [Enter]where XXXX is the adapter’s port address and NAME X and Yare names that you assign to help distinguish the multipleadapters. (To determine the port address, refer to thesection “Finding the Adapter’s Port Address” earlier in thischapter.)If the load sequence above is not followed, the system willnot operate correctly. Make sure that the PORT=XXXXparameter is completed for all adapters.3 When this has been done, bind the protocol to theuser-assigned names.When running the 3C59X.LAN driver with NetWare 3.11,you must update the MONITOR.NLM file that accompaniedNetWare 3.11 with the MONITOR.NLM file from Novell.For the latest NLMs, contact Novell. |
Related manuals for 3Com EtherLink 3C590
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine