Changing Driver Configuration Parameters 49Changing Driver Configuration ParametersYou can change parameters from the installation programConfiguration screen. Table 3 lists the parameters shownon the Configuration screen. Default values are shownin bold.Follow these steps to change parameters:1 From the Configuration screen, selectSelect/Modify driver parameters and protocols.The Select a Protocol box is selected.2 To add a network protocol, select the desired protocolfrom the Protocols box and press Enter.IPX is the default protocol. If you select TCP/IP, supply theTCP/IP addresses as follows:a Type the IP address.b Type the IP subnet mask.c Press F10 to continue.Table 3 NetWare Installation Program Configuration ParametersParameterRange of Values(Defaults in Bold) DescriptionSlot Number All PCI slot numbers validto the systemRepresents the PCI slot number ofthe physical NIC to be configured.Node Address Default is factory-assignedMAC address.Leave blank to usefactory-assigned default.Link AutoOffDetermines whetherauto-negotiation is enabled(Auto) or off. Off defaults tolink signal detection only.Rx Flow Control AllowOffDetermines whether receptionflow control is enabled (Allow) ordisabled (Off).Tx Flow Control AllowOffDetermines whether transmissionflow control is enabled (Allow)or disabled (Off).FDR Filtering OffOnDetermines whether the fullduplex repeater filter is enabled(On) or disabled (Off).
