Windows 95 Setup 2-5Figure 2-3 non–Plug and Play BIOS Detected ScreenTo install the NIC using the 3Com Installation Wizard Expressinstallation option, see the EtherLink III ISA Network InterfaceCard Quick Guide that shipped with the 3C509B NIC. To set upthe NIC for installation using the 3Com Installation Wizard Custominstallation option, go to the next section.Configuring the NIC in a Plug and Play PCThis section describes how to set up your system environmentwhen installing the NIC in a Windows 95 PC that has aPlug and Play BIOS installed.Follow these steps to configure the NIC:1 Turn the power on and boot Windows 95.The New Hardware Found screen appears. Then the UpdateDevice Driver Wizard screen is displayed, as shown in Figure 2-4.Figure 2-4 Update Device Driver Wizard Screen
