DUA1840-0AAA01About the MSH Switch 1005 1-3n SmartAgent supportn SNMP with IP and IPX protocolsn RMONn Repeater and Bridge MIBn Broadcast storm controln Easy software upgradesn BOOTPn Local managementPort Connections10BASE-T Switch PortsEight fixed ports each configured as MDIX provide 10Mbps bandwidthto each attached end-station. Maximum segment length is 100m(328ft) over grade 3, 4 or 5 twisted pair cable.Internal Switch PortsAs well as switch ports located on the front panel of the Switch 1005,internal backplane connections provide an additional four switchports. These ports are enabled and disabled through management orusing the set of links LK1 to LK5 located on the Switch 1005.Three of these ports provide switched connections to the three10Mbps repeater backplanes located in the MSH chassis, and thereforeto any modules connected to the same backplane.The fourth internal switched port provides a connection to the FastEthernet backplane, and therefore to any other Switch 1005 modulesinstalled in the chassis.Locating and setting links is described in “Setting the Links on theSwitch 1005” in Chapter 2.