4-2 CHAPTER 4: MANAGI NG YOUR HUB USING QUICK CONFIG M ANAGERInstallation ProcedureQuick Config Manager can be installed on its own oron to a workstation that already has otherTranscend® management applications installed on it.CAUTION: Do not install Quick Config Manager inthe same directory as any other Transcendmanagement applications. The default directory intowhich Quick Config Manager is installed isC:\QUICKMGR. This can be changed during theinstallation if required.The installation program is a standard Windowsbased installation. To install Quick Config Manager:1 Start Windows.If you already have an existing Transcendmanagement application running, ensure that it isclosed down.2 Insert the Quick Config Manager disk into your diskdrive.3 In the Program Manager window, select the Runcommand from the File menu.4 In the Command Line box, typedrive:\SETUP(wheredrive is the letter of your 3.5” disk drive)and click on OK.The installation program starts and checks yoursystem configuration; enter any information that’srequested. The installation program reports when ithas completed the installation.When the Quick Config Manager installation iscomplete, it has its own program group calledTranscend. If other Transcend managementapplications are present, the existing Transcendprogram group now includes Quick Config Manager.Running Quick Config ManagerWhenever you want to start the Quick ConfigManager application, double-click on the QuickConfiguration Manager icon.CAUTION: Do not run Quick Config Manager inparallel with any other Transcend managementapplication.Before you can manage your hub, you must make aconnection to the hub, see Chapter 3.16710.bk : MANAGING.FRM Page 2 Tuesday, October 7, 1997 11:38 AM