120 CHAPTER 6: IP ROUTING P ROTOCOL OPERATIONExample: Typical RIPConfigurationNetworking RequirementsAs shown in Figure 33, Switch C connects to the subnet 117.102.0.0 through theEthernet port. The Ethernet ports of Switch A and Switch B are connected to thenetworks 155.10.1.0 and 196.38.165.0 respectively. Switch C, Switch A andSwitch B are connected via Ethernet 110.11.2.0. Correctly configure RIP to ensurethat Switch C, Switch A and Switch B can interconnect.Networking DiagramFigure 33 RIP configuration networkingConfiguration ProcedureThe following configuration only shows the operations related to RIP. Beforeperforming the following configuration, please make sure the Ethernet link layercan work normally and the IP addresses for the VLAN interfaces are configured.1 Configure RIP on Switch A[Switch A]rip[Switch A-rip]network 110.11.2.0[Switch A-rip]network 155.10.1.02 Configure RIP on Switch B[Switch B]rip[Switch B-rip]network 196.38.165.0[Switch B-rip]network 110.11.2.0Enable the debugging of RIP receiving packet debugging rip receiveDisable the debugging of RIP receiving packet undo debugging rip receiveEnable the debugging of RIP sending packet debugging rip sendDisable the debugging of RIP sending packet undo debugging rip sendReset the system configuration parameters of RIP resetTable 121 Displaying and Debugging RIPOperation CommandEthernetNetwork address:110.11.2.2/24Network address:117.102.0.0/16Network address:196.38.165.0/24Interface address:110.11.2.1/24Interface address:117.102.0.1/16Interface address:155.10.1.1/24Network address:155.10.1.0/24Interface address:196.38.165.1/24SwitchASwitchBSwitchC