User Interface Configuration 31User InterfaceConfigurationTasks for configuring the user interface are described in the following sections:■ Entering User Interface View■ Configuring the User Interface-Supported Protocol■ Configuring the Attributes of AUX (Console) Port■ Configuring the Terminal Attributes■ Managing Users■ Configuring RedirectionEntering User Interface ViewUse the user-interface command to enter a User Interface View. You can entera single User Interface View or multi User Interface View to configure one or moreuser interfaces respectively.Perform the following configuration in System View.Configuring the User Interface-Supported ProtocolThe following command is used for setting the supported protocol by the currentuser interface. You can log in to the Switch only through the supported protocol.The configuration becomes effective when you log in again.Perform the following configurations in User Interface (VTY user interface only)View.By default, the user interface supports Telnet and SSH protocols.If the Telnet protocol is specified, to ensure a successful login through Telnet, youmust configure the password by default.If SSH protocol is specified, to ensure a successful login, you must configure thelocal or remote authentication of username and password using theauthentication-mode scheme command. The protocol inbound sshconfiguration fails if you configure authentication-mode password andauthentication-mode none. When you configure SSH protocol successfully forthe user interface, then you cannot configure authentication-mode passwordand authentication-mode none any more.Configuring the Attributes of AUX (Console) PortUse the speed, flow control, parity, stop bit, and data bit commands toconfigure these attributes of the AUX (console) port.Table 10 Entering User Interface ViewOperation CommandEnter a single User Interface View or multi UserInterface Viewsuser-interface [ type ]first-number [ last-number]Table 11 Configuring the User Interface-supported ProtocolOperation CommandConfigure the user interface-supportedprotocolprotocol inbound { all | ssh |telnet }
